After cutting, NC flame steel plate cutting machine should check the steel cutting surface, mainly check whether there are cracks, slag and other problems on the cutting surface of ABS AH36 marine steel plate. The inspection method is generally visual ins
2021-12-02
Incision width: the dimension of the widest part of the incision, usually 0. 15-6mm. If the cutting width is not appropriate, it will cause waste of BV AH32 steel plate, reduce cutting speed and increase energy consumption. Surface roughness of BV AH32 st
2021-12-02
Large flange refers to a flange that exceeds the size specified by the relevant part of the country. There are three production processes for large flange pieces: casting, rolling and splicing. The production of such flanges must be produced by the constr
2021-11-05
Most of these products are weighed by theoretical weight. In the calculation, the weight of the waterline, spigot, bolt hole, and chamfer is not reduced. First cut the middle plate into suitable slivers. The quality of the slivers is determined by the spe
2021-11-05
Stainless steel flange pipe fittings will not produce corrosion, pitting, rust or wear. Stainless steel is still one of the strongest materials among the metal materials used in construction.
2021-11-05
The steel gate is mainly welded with steel plate as the base material. The steel gate is corrosion-resistant, and the rubber sealing ring can be used to seal the water. According to the increase of the water head, the gate can be equipped with grooved pul
2021-10-26